Hubbardton-forge 104325 Instrukcja Użytkownika Pobierz pdf

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

30264

Installation Instructions

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.

We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

To Assemble Fixture (Figures 1 & 2)

Component Parts

A Cap

B Wire connector

C Bob

D Fixture pipe

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX

PRIOR TO INSTALLATION.

1. Carefully unpack the xture from the carton.

2. Spin xture loop (O) counter clock wise to remove it. Set

aside along with cap (A).

3. Remove lock washers and nuts shipped installed on xture

pipes (D) and set aside for later use.

4. Run power cord and ground wire from xture through one

xture pipe (D), hook (E) end rst.

5. Feed wires followed by swivel end of xture pipe (D) through

hole in the bob (C). Attach with lock washer and nut, leaving

nut loose.

6. Slide hook (E) into loop (F) pulling wires tight.

Note: Wire fed through hoop (F) and hook (E) must be facing

outside of xture to avoid being pinched.

7. Slide hook (E) into loop (F) pulling wires tight.

Note: Terminals are shipped attached to power cord & ground.

8. Pass swivel on remaining two fixture pipes (D) through bob

9. Secure remaining two fixture pipes (D) to fixture by feeding

hooks (E) through loops (F).

10. Tighten all three nuts to bob (C). Tuck wires into bob (C) and

lower cap (A) over the wires being careful not to pinch them.

Follow with fixture loop and twist until tight.

11. Follow next steps to install canopy and hang fixture.

A348

For Moreau 7 Light Chandelier 104325

Page 1 of 3

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

(Figure 2)

(Figure 1)

(Continued)

E Hook

F Loop

O Fixture loop

FIXTURE WIRE

(WHITE OR BLACK)

CANOPY WIRE

1 2 3

Installation Instructions 1

Podsumowanie treści

Strona 1 - Installation Instructions

Strona 2

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product. We hope you en

Strona 3

Komentarze do niniejszej Instrukcji

Brak uwag

Hubbardton-forge 104325 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Oświetlenie Hubbardton-forge 104325. Hubbardton Forge 104325 User Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oświetlenie Hubbardton-forge 104325